KanexPro Support Assistant

Describe your setup, the part number, and what you are seeing.

Before we start

So the team can follow up if this needs a person.

Used only to follow up on this request. See our Privacy Policy.

General enquiry

Tell us what you need and the right person will come back to you.

Used only to answer you. See our Privacy Policy.

Support › Knowledge base › SDI-HDRPTPRO

SDI-HDRPTPRO SDI Repeater: Formats, Reach and Uses

SDI-HDRPTPRO SDI-HDRPTPRO HD-SDI Repeater with Signal Equalization & Re-clocking Extend SDI or Daisy chain multiple SDI repeaters to create longer runs Product page →

The SDI-HDRPTPRO is a one-in, one-out SDI repeater. It equalizes and re-clocks an incoming 3G-SDI, HD-SDI or SD-SDI signal and sends a clean signal on down the coax, so one cable run can be extended. Units can also be daisy-chained to build longer runs. It is for integrators and facility engineers who work in surveillance systems, rental and staging, post-production, TV studios and digital cinema.

Applies to: SDI-HDRPTPRO HD-SDI Repeater with Signal Equalization & Re-clocking.

What does the SDI-HDRPTPRO do in an SDI system?

It sits in the middle of a coax run, between an SDI source and the downstream equipment. It has one SDI input and one SDI output. A built-in cable equalizer recovers the signal after the length of coax it has just travelled, and the re-clock function regenerates the timing before the signal goes out again. The input is detected automatically across 3G, HD and SD-SDI, so you don't set the format by hand when the source changes. The housing is compact and rugged and has mounting ears. The power supply locks in place. A Micro-USB port is provided for firmware updates.

Which SDI formats and resolutions does it accept?

It passes 3G-SDI, HD-SDI and SD-SDI. These are the supported video resolutions:

  • 3G: 1080p60 / 59.94 / 50
  • HD: 1080p30 / 29.97 / 25; 1080i60 / 59.94 / 50; 720p60 / 59.94 / 50
  • SD: 625i (PAL) / 525i (NTSC)

This range covers full HD 1080p/60 production feeds as well as legacy standard-definition sources that are still found in surveillance and broadcast plants.

Does the repeater carry embedded audio?

Yes. Embedded audio of up to 16 channels at 24-bit@48KHz passes through with the video. The repeater also passes ancillary data. You don't need a separate audio run alongside the coax.

How much coax can the cable equalizer handle?

The specification table rates the cable equalization by SDI rate and cable type. For an HD-SDI signal, the equalizer is rated for 200m of RG6 or 140m of RG59. For a 3G-SDI signal, it is rated for 140m of RG6 or 100m of RG59. These are the lengths of cable the equalizer is rated to recover at the repeater's input. Plan each segment of the run against the figure for the SDI rate you are actually sending and the cable you are actually pulling.

Can several repeaters be daisy-chained for a longer run?

Yes. The SDI-HDRPTPRO is designed to be daisy-chained with additional SDI repeaters. Each unit re-equalizes and re-clocks the signal before passing it on. This suits long rental and staging cable paths, signal runs across a large building, or camera feeds in a surveillance plant where the source is a long way from the equipment that receives it.

What power, approvals and warranty does it have?

The unit takes DC in at 7.5V ~ 15V and has a locking power connector. It carries FCC, CE and UL approvals and a 3-Year parts and labor warranty.

Key specifications

Input1 x SDI
Output1 x SDI
SDI formats3G-SDI, HD-SDI, SD-SDI
Cable EqualizationHD: 200m of RG6; 140m of RG59; 3G: 140m of RG6 100 m of RG59
Supported Audio Formatsup to 16-channels, 24-bit@48KHz
PowerDC in: 7.5V ~ 15V
Regulatory ApprovalsFCC, CE, and UL
Warranty3-Year parts and labor
--- 1. **The customer question isn't answered.** The only question was about NDAA compliance, and nothing in the facts says whether the product is compliant. The article leaves it out, so that question still needs an answer from someone who knows. 2. **The facts give conflicting distances, so I used only the specification table.** The feature list says 300m, 170m and 130m, but the specification table says 200m/140m for HD and 140m/100m for 3G. The table's figures appear only next to an SDI rate, never next to a resolution. There's no SD distance because the table doesn't give one. The approved FAQ also lists different distances (including 400m for SD), and those should be checked against the table. 3. **Audio follows the table too.** The table says up to 16 channels, while the overview and the old FAQ say 7.1. The article uses the table's 16 channels.